Silvercrest 373080 2104, Operating Instructions Manual, Page: 18 / 202

GB │ IE │ 15 ■ SNAW 1000 D2
Display Possible cause Remedy
The readings on the
display
3
become
illegible.
The batteries are very low. Replace the batteries.
No output on the
display
3
.
The plastic strip in the bat-
tery compartment
2
has
not been removed.
The batteries are dead.
Remove the plastic strip from the
battery compartment
2
.
Replace the batteries.
"E" appears on the
display
3
.
The permitted maximum
values were exceeded. Observe the maximum values
specified in these instructions.
"0-Ld" appears on
the display
3
.
The appliance is over-
loaded. Remove some weight from the
weighing platform
1
.
"Lo" appears on
the display
3
.
The batteries are too weak
to carry out a weighing.
Replace the batteries.
NOTICE
► If you cannot resolve the problem with the above steps, please contact
Customer Support.
Disposal
Disposal of the appliance
Do not dispose of the appliance in your normal domestic waste.
This product is subject to the European directive 2012/19/EU.
Dispose of the appliance through an approved disposal centre or at your community
waste facility. Observe the currently applicable regulations. In case of doubt,
pleasecontact your waste disposal centre.
Your local community or municipal authorities can provide information on how to
dispose of the worn-out product.
The product is recyclable, subject to extended producer responsibility and is
collected separately.
Disposing of the batteries / cells
Used batteries / cells may not be disposed of in household waste. Every consumer
is legally obliged to dispose of batteries at a collection site in his community / city
district or at a retail store. The purpose of this obligation is to ensure that batteries /
cells are disposed of in a non-polluting manner. Only dispose of batteries / cells
when they are fully discharged.