SilverCrest SMRB 40 A1
52 - English
other end into the corresponding port of your router. In this case you don't need to register the
sound bar in your Wi-Fi network to control it with the SilverCrest Smart-Audio app.
In order for the sound bar to access the music files on the network, the network must meet the
following requirements:
DHCP must be enabled on the network router so the sound bar can obtain an IP address
automatically.
UPnP media sharing has to be enabled on the router.
See the operating instructions for your router.
Inserting the batteries into the remote control
Open the battery compartment on the back of the remote control by sliding the battery
compartment cover in the direction shown and removing it. Insert the batteries (2 AAA-type
batteries) with the correct polarity (+ and -). The correct polarity is labelled on the batteries and
inside the battery compartment. Re-insert the cover of the battery compartment and slide it in the
opposite direction of the arrow until it locks in place.
LED indicators
orange LED on
Idle mode
yellow LED on and blue LED on
Sound bar initialising
blue LED flashes slowly
AP mode, waiting for network
connection
Pairing mode, waiting for Bluetooth
®
connection
blue LED flashes 3 times fast, followed by a
short pause
WPS mode, waiting for WPS signal from
router
blue LED on
Connected to the network
green LED on
AUX mode
SPDIF mode (optical input)
green and blue LEDs flashing fast
Wi-Fi connection fault
green and blue LEDs flashing slowly two times
Maximum volume has been reached
