Silvercrest 274393, Operating Instructions Manual

Page: 27 / 272

GB
│
IE
│ 23 ■ SKM 550 B1
After using your appliance
1) Switch the appliance off using the rotary
switch
.
.
2) Turn the continuous shredder anti-clockwise
and remove it.
3) Disassemble the continuous shredder and
clean all parts as shown in the section “Clean-
ing and care”.
Working with the blender
WARNING! RISK OF INJURY!
► Allow hot fluids to cool to a lukewarm tem-
perature (approx. 30 - 40°C) before pouring
them into the blender
.
WARNING! RISK OF INJURY FROM
SHARP KNIFE/ROTATING DRIVE!
► Never put your hand into the attached
blender
while it is running!
► Remove the blade from the blender only
when it is at a complete standstill.
► Only use the blender with the lid firmly in
position.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
Proceed as follows to prepare the appliance for
operation using the blender
:
1) Press down the release button ! and move
the pivot arm
0
into operating position 3
(see the section “Operating positions”).
2) Remove the protective cover for the blender
drive hub (turn so that the marking “ ” on
the protective cover for the blender drive hub is
in line with the marking “ ” on the appliance
itself) (Image F).
3) Position the blender on top of the appliance
(so that the marking “ ” on the blender
lines up with the marking “ ” on the appli-
ance).
Turn the blender anti-clockwise until the stop
(so that the marking “
” on the blender
lines up with the marking “ ” on the appli-
ance itself) (Image G).
4) Add the ingredients.
–
Maximum fill quantity: approx. 1 litre;
–
Foaming liquids, maximum 0.5 litre;
–
Ideal processing quantity for solids: 50 - 100 g.
NOTE
► Take note of the table in the section
"Recommended filling quantities".
5) Place the lid onto the measuring jug slightly
offset and then turn it until the lid clicks into
place (Image I).
6) Turn the rotary switch . to the required setting.
Adding more ingredients
1) Switch the appliance off using the rotary switch
.
.
2) Rotate the lid of the blender a little (Image I),
remove the lid and add the ingredients you
want to mix
or
3) Rotate the measuring jug, which is placed in
the lid of the blender , by 90° and remove it.
Then gradually add the solid ingredients
using the opening provided for this purpose.