Silvercrest 102870, Operating Instructions Manual

Page: 18 / 111

15
SDI 3500 A1
GB
Troubleshooting
PROBLEM POSSIBLE CAUSE
POSSIBLE
SOLUTIONS
The appliance is not
working. The indicator
light above the ON/OFF
button
e
fails to come on.
The plug is not connected.
Connect the appliance to
a mains power socket.
The appliance is damaged.
Contact the Customer
Service department.
The appliance does not
start the cooking process.
There is no vessel on the
respective hob
1
/
2
.
Place a suitable vessel on
the respective hob
1
/
2
.
The vessel is not suitable
for induction hobs.
Use a suitable vessel
(see the "Suitable
cookware" section).
E0 is shown on one of the
displays
0
/
u
.
There is no vessel on the
respective hob
1
/
2
.
Place a suitable vessel on
the respective hob
1
/
2
.
E2 is shown on one of the
displays
0
/
u
.
The temperature sensor
beneath the hob
1
/
2
is
defective or there is a short
circuit.
Disconnect the plug from
the mains power socket
and contact the Customer
Service department.
E3 is shown on one of the
displays
0
/
u
.
The appliance is being
supplied with too much
voltage (>270 V).
Check and ensure that the
appliance is connected
to a properly installed
mains power socket with
220–240 V ~, 50 Hz.
E4 is shown on one of the
displays
0
/
u
.
The appliance is not being
supplied with enough voltage
(<150 V).
Check and ensure that the
appliance is connected
to a properly installed
mains power socket with
220–240 V ~, 50 Hz.
E5 is shown on one of the
displays
0
/
u
.
The appliance has overheated.
Disconnect the plug from
the mains power socket
and wait until the appliance
has cooled down.
E6 is shown on one of the
displays
0
/
u
.
The appliance has overheated.
Disconnect the plug from
the mains power socket
and wait until the appliance
has cooled down.
IB_102870_SDI3500A1_LB4.indb 15 12.11.14 08:48