8
SHBS 600 A1
GB
Operation with the mains power adapter
If your hair and beard trimmer stops working during shaving due to a discharged
or weak battery, you can continue shaving by plugging in the mains power
adapter
9
.
♦
Plug the cable plug of the mains power adapter
9
into the socket
8
on the
underside of the hair and beard trimmer.
♦
To avoid injuries and damage to the appliance, always switch the appliance
off before connecting it to the power supply.
♦
Plug the mains power adapter
9
(wide-range voltage 100–240 V) into a
power socket complying with the appliance specifi cations.
♦
After 1–2 seconds, you can switch the appliance on by pressing the ON/OFF
switch
6
. If the appliance does not start immediately, switch it off again and
wait around 1 minute before switching it on again.
Oiling the cutting units
We recommend that you oil the cutting unit
before fi rst use and after cleaning
to ensure full mobility.
♦
To do this, simply apply a couple of drops of blade oil (accessory) between the
blades, and then distribute it evenly.
♦
Wipe off any access oil with a soft cloth. Use only non-corrosive oils such as
sewing machine oil.
Handling and operation
Attaching/changing the cutting length attachments
The cutting length attachments
10
and
11
off er settings for 10 diff erent cutting
lengths (4/7/10/13/16/18/21/24/27/30 mm).
♦
Push the respective cutting length attachment (
10
or
11
) onto the cutting unit
from above so that the two side rails slot into the provided guides.
♦
Push the cutting length attachment (
10
or
11
) down until it snaps into place on
the mounting points
4
.
♦
To remove the cutting length attachment, move the slide switch for cutting length
adjustment
5
upwards (position 5) and then pull the cutting length attachment
(
10
or
11
) upwards off the appliance.
IB_102827_SHBS600A1_LB4.indb 8
23.10.14 13:37
Summary of Contents for 102827
Page 3: ...A D E F B C ...
Page 59: ...56 SHBS 600 A1 SI ...
