9
SHBS 600 A1
GB
Setting the cutting length
♦
To set the various cutting lengths, press and hold the release button on the slide
switch
5
and slide it to the desired position (1–5). The set cutting length can be
read on the side of the appliance.
Cutting hair
NOTE
►
The hair to be cut should be clean and dry.
►
Comb the hair carefully to remove any knots.
►
Place a hairdressing cape or a cloth around your neck and throat to stop
hair trimmings from falling inside your collar.
►
Start by setting the cutting length attachment (
10
or
11
) to a longer length
and reduce this in stages while cutting the hair.
►
Please note that the corresponding cut length will only be achieved if the
appliance is being held at right angles to the skin surface.
♦
Switch the hair and beard trimmer on by pressing the ON/OFF switch
6
.
♦
Run the hair and beard trimmer slowly through your hair.
♦
When doing so, hold the appliance so that the cutting length attachment (
10
or
11
) is as fl at as possible against your scalp.
♦
Always cut from your neck towards the top of your head, or from your forehead
and temples upwards towards the middle of your head.
♦
Use the cutter unit
without the cutting length attachment (
10
or
11
) to cut the
hair very short.
Thinning your hair
The hair and beard trimmer has a thinner attachment
2
to thin out thick hair
growth.
♦
Push the slide switch for the thinner attachment
3
left as far as the stop to the
position
in order to position the thinner attachment
2
in front of the cutting
unit
. The thinner attachment
2
prevents the cutting unit
from cutting every
hair.
♦
Push the slide switch for the thinner attachment
3
right as far as the stop to
position 0 when you no longer want to use the thinner attachment.
IB_102827_SHBS600A1_LB4.indb 9
23.10.14 13:37
Summary of Contents for 102827
Page 3: ...A D E F B C ...
Page 59: ...56 SHBS 600 A1 SI ...
