Operation Manual
S15
Page
10
Note that the radio will not transmit, nor will alternative channels be able
to be selected while in dual watch mode. To restore normal operation
press
(F)
key again or press channel
(16)
key.
4.2 FULL SCAN (FS)
This function scans through each channel sequentially until a signal is
detected above the squelch level set. Once the signal ends or drops
below the squelch level, the radio will continue scanning. Since the scan
function stops on channels where a
signal is detected, the radio will be
locked. If you want the scan continue, press
▲
key once. When in Full
Scan mode, FS will appear on the bottom line of LCD.
Note that the radio will not transmit, nor will alternative channels be able
to be selected while in Full Scan mode. To restore normal operation
press
(F)
key or press channel
(CH16)
key to go to back to VHF screen.
4.3. MEMORY SCAN (MS)
The Memory Scan operates in the same way as the Full Scan, except
that it will only scan channels that have been entered into the Scan
Memory. If no channels have been entered into the memory then this
function will not available. See 4.9, Page 12.
When in memory scan mode, “MS” will appear on the bottom line of the
LCD.
4.4 HIGH/LOW RF OUTPUT POWER SELECTION
Press
▲
or
▼
key to move the
►
symbol on the FUNCTION
SELECTION screen to required function “H/L POWER”, then press the
(ENT)
key for selection of low or high power, then the “Hi” or “Lo” will
appear on the bottom line of the LCD.