ZigBee Communications Gateway
©2016 Silicon Labs
-12-
ZigBee Communications Gateway
4.5 Buttons Actions
The Gateway has three hardware buttons as shown in the
Layout
which can perform multiple
functions as described in this section.
1. Button 1 (B1)
2. Button 2 (B2)
3. Button 3 (B3)
Restore factory defaults
Follow the following procedure with buttons in order to restore the factory default configuration
settings on the Gateway using
B3
and
B1.
1. Press and hold
B3
2. Then with
B3
pressed, press and hold
B1
for approximately 3 seconds after which the
Gateway reboots and LED power up sequence is seen.
Gateway reboot
Press
B3
and hold for 5 seconds to reboot the Gateway.
Gateway recovery mode
Perform following procedure to put the Gateway in recovery mode
2
.
1. Press and hold
B3
until gateway reboots.
2. At power up hold
B2
and wait for 3 seconds.
3. The Gateway will be in recovery mode now.
Issue ZigBee command
Button
B2
is used to issue custom ZigBee command to the 1
st
ETRX3 ZigBee module which can be
configured in Button Command section of the
Gateway Configurations
as shown below.
So whenever the B2 i
s pressed the command (“AT+BCAST:00,hello” by default) is issued to the 1
st
ETRX3 ZigBee module.
2
Recovery mode not implemented in initial release but will be added in subsequent release soon.
