S i 5 3 6 5 / 6 6 - E V B S i 5 3 6 7 / 6 8 - E V B S i 5 3 6 9 - E V B
10
Rev. 0.6
J14 is a three-pin by ten header that is used to establish input levels for the pin controlled two-level inputs using
jumper plugs. It also provides a means of externally driving the two-level input signals:
J8 is a 20 pin ribbon header that provides an external path to monitor the status pins.
J22 is a 10 pin ribbon header that provides an external path to serially communicate with the Any-Frequency
Precision Clock.
To control the Any-Frequency part that is on the Evaluation Board from an external serial port, open the Register
Programmer, connect to the Evaluation Board, go to Options in the top toolbar and select "Switch To External
Control Mode".
To control an Any-Frequency part that is on an external target board from the Evaluation Board using its serial port,
tie pin 9 of J22 low so that the on-board Any-Frequency part is constantly being held in reset. This will force it to
disable its SDA_SDO output buffer.
Table 4. Two-Level Input Jumper Header, J14
J36
Pin
Comment
J14.1B
CS0_C3A
CS0
J14.2B
CS1_C4A
CS1
J14.3B
INC
J14.4B
DEC
J14.5B
—
not used
J14.6B
—
not used
J14.7B
DSBL34
J14.8B
FS_ALIGN
J14.9B
FS_SW
J14.10B
CK_CONF
Table 5. External Status Connector, J8
J37
Pin
Comment
J8.1
LOL
J8.3
C1B
J8.5
C2B
J8.7
C3B
J8.9
C1A
J8.11
C2A
J8.13
CS0_C3A
C3A
J8.15
CS1_C4A
C4A
J8.17
INT_ALRM
J8.19
DUT_PWR
