Silicon Graphics Zx10, User Manual

Page: 63 / 78

Exit Screen
007-4330-002 49
• Press
–
to move a device down in boot order.
You can select to boot from removable devices, a specific hard disk drive, the CD-ROM
drive, or a disk drive on the network.
Exit Screen
The Exit screen lets you control the changes made to the BIOS and exit from BIOS Setup.
Using CMOS Reset
CMOS reset instructs the BIOS to use factory settings, clears BIOS passwords, and runs
BIOS Setup at system boot. See Chapter 2, “Components” for the location of the CMOS
reset jumper connector on the system board.
To use CMOS reset:
1. Turn off system power and disconnect the system from AC power.
2. Install a jumper on the CMOS reset connector (J29) on the system board.
3. Connect the system to AC power and start the system. BIOS Setup runs
automatically.
4. Reconfigure the BIOS parameter settings as needed.
Table 3-5 Exit Screen Parameters
Parameter Description
Exit Saving Changes Saves the changes you have made, exits the BIOS, and restarts the
system to make these changes take effect.
Exit Discarding Changes Leaves the previous BIOS settings intact, exits the BIOS, and
continues with the operating system boot.
Load Setup Defaults Returns all BIOS parameters to their original default settings (as
shipped from the factory).
Discard Changes Discards any changes you have made, but does not exit the BIOS.
Save Changes Saves any changes you have made, but does not exit the BIOS.