Silicon Graphics Origin200, Owner'S Manual

Page: 14 / 288

xiv
List of Figures
Figure 2-14
Attaching the SCSI Cable to a 5.25-Inch Drive 47
Figure 2-15
Replacing the Rear Access Plate on the Peripheral Carrier 48
Figure 2-16
Replacing the 5.25-Inch Peripheral Carrier 49
Figure 2-17
Attaching an Ethernet Networking Cable to an Origin200 Module 50
Figure 2-18
Attaching the Serial Cable 51
Figure 2-19
Removing the Side Panel of the Second (Slave) Module 53
Figure 2-20
Removing the Module System Controller (MSC) Access Plate 54
Figure 2-21
MSC DIP Switch Location and Settings 55
Figure 2-22
Attaching the Grounding and CrayLink Cables 56
Figure 2-23
Turning On the Master Power Switch 57
Figure 2-24
Turning On the Front Power Switch 58
Figure 3-1
Placing the Origin200 on a Work Surface 65
Figure 3-2
Origin200 Rackmounting Ears 66
Figure 3-3
Attaching the Rackmounting Hardware (Ears) 67
Figure 3-4
Installing the Rackmounting Shelf 68
Figure 3-5
Lifting the Origin200 Server Into a Rack 69
Figure 3-6
Attaching the Plastic End Caps to a Rackmounted Server 70
Figure 4-1
The Origin200 Front Panel 76
Figure 4-2
Turning On the Master Power Switch 80
Figure 4-3
Turning On the Front Power Switch 81
Figure 4-4
Turning Off the Front Power Switch 84
Figure 4-5
Turning Off the Master Power Switch 86
Figure 4-6
Attaching a Serial Cable to Port 1 of the Origin200 Server 90
Figure 4-7
Location of the AUX Port 98
Figure 4-8
Example /hw Filesystem 110
Figure 5-1
Locking the Chassis With the Locking Tabs 114
Figure 5-2
Adjusting the Feet 115
Figure 5-3
Removing the Front Door, Tower Configuration 116
Figure 5-4
Removing the Front Door, Rackmount Configuration 117
Figure 5-5
Removing the System Cover, Tower Origin200 System 119
Figure 5-6
Opening the Chassis Access Door, Tower Origin200 System 120
Figure 5-7
Removing the Top Cap 122
Figure 5-8
Removing the Lower Bezel 123
Figure 5-9
Removing the Pedestal Assembly (Feet) 124