Silicon Graphics CHALLENGE Vault L CMN A01, Owner'S Manual

Page: 25 / 32

Removing a Drive Shelf
13
4. Carefully insert the device into the drive bay until it seats firmly into
the lever catch and move the locking lever all the way to the right.
5. After you have installed all of the drives, you can power on the drive
box and rack. See Figure 1-2 in Chapter 1, “Touring the Chassis,” earlier
in this guide for the location of the power switch.
Caution: Recheck the SCSI ID of the drives to make sure you do not
duplicate numbers.
Removing a Drive Shelf
Full-height drives require two half-height drive slots. To install a full-height
drive, you must first remove a drive shelf from the Vault L using these
instructions:
1. Open the front door of the Vault L.
2. Select a drive shelf for removal, then remove the two screws that secure
the drive shelf to the sides of the Vault L chassis (see Figure 2-4).