Silicon Graphics CHALLENGE Vault L CMN A01, Owner'S Manual

Page: 19 / 32

Rear View Components
7
The following major components are located on the back of the Vault L
storage box:
SCSI In (A/B) provides a 68-pin SCSI-2 differential connector.
Note: Each SCSI box provides two SCSI In connectors for disk striping and
increased I/O throughput.
SCSI Out (A/B) provides connection for SCSI termination or a daisy-chain
connection to a second Vault L or another SCSI device.
Voltage Selector Switch
selects between 115 and 230 volts.
Caution: To prevent possible damage to the Vault L, always ensure that the
voltage selection matches the power source input.
Warning:
Do not attempt to connect the Vault L to the host system.
Installation should be performed only by Silicon Graphics-certified
personnel.
Installation of these upgrades requires specific training and technical
knowledge. This equipment utilizes electrical power internally that is
hazardous if the equipment is improperly disassembled.
This equipment is also extremely sensitive and is susceptible to damage
caused by electrostatic discharge (ESD). ESD is an electrical discharge
(spark) caused by the buildup of electrostatic potential on clothing and
other materials.