Silicon CPV Ltd
Akhter House, Perry Road, Harlow, Essex, CM18 7PN, UK
Tel +44 (0) 1279 821200 Email [email protected]
Page 10 of 24
Installation Instructions for Kamr
–
Part 2
Fixing the Solar Street Light to the Pole
Warning
: During the installation of the street light, operative(s) will be
required to carry out work at heights sufficient to cause personal injury in
the event of a fall, as such it is important to observe safe working practices
to ensure their own and any others protection, including the use of the
appropriate Personal protective Equipment (PPE).
Please complete the following steps below to correctly install the Kamr Solar
Street Light.
1.
For this task you will need a powered drill with a 4.5mm HSS drill bit
and the 3 off Security Self Tappers Pin Torx BH - 10 x 3/4" (4.8 x
19mm) supplied in the light carton
2.
Mount the street light on the pole as shown below and correctly align
with the road
3.
Drill three pilot holes equally spaced around the circumference of the
pole and approximately 80mm from the light head
4.
With the screws supplied fix the light to the pole
5.
Ensure the switch is set to “ON”
(button level with the switch bezel).
