1) MARK REFERENCE POINTS ON WALL
The bottom of the range hood must sit between 26”
(min) and 36” (max) above the stove top. The screw
holes must be situated 13-1/2” above the point where
the bottom of the range hood will hang. The screw
holes for mounting the range hood must be 9” apart.
Refer to Fig. 2 and mark these reference points on
the wall before installing the range hood. Then, drill
2 screws into the wall but not tightly: you must leave
some of the screw (roughly half an inch) out of the wall
until after the range hood is mounted.
2) MOUNTING THE RANGE HOOD ON THE
WALL
Before mounting the range hood on the wall please take out
the fi lters and remove any plastic or styrofoam found inside
the range hood (see Fig. 3 and Fig. 4.) Leave the fi lters out
until Step 3 is fi nished.
FIG. 4 - PEEL OFF PLASTIC FROM THE FLUES
FIG. 2
26” min
34” max
CEILING
9”
13-1/2”
F & H
F & H
INSTALLATION INSTRUCTIONS
4
A
Separate the extension flue by
pulling it upward.
19-5/8”
19-1/8”
Remove the plastic
found on the flues.
FIG. 3
Remove filters and
styrofoam pieces
from inside the
rangehood.
1.Push in tab
2.Pull downward
