UM_FULL_55SL_REV_A
7
REMOTE START OPERATION
A. TO REMOTE START THE VEHICLE:
When you want to start your vehicle;
1. Press the button once on the transmitter.
2. The parking light will activate to indicate the remote start received the signal.
3. The engine will start in approximately 5 seconds.
4. Once the engine is running, after a couple seconds the parking lights will turn on and the climate controls will activate
and adjust the vehicle’s interior temperature to your preset settings. (While the vehicle is running, the “minutes” digit on
the LCD screen will flash and will indicate the countdown timer based on the 5, 10, 20 or 30 minute run time set up by
your installation center.)
5. The vehicle will run for a programmable 5 to 30 minute cycle before shutting down. (When the unit shuts off the
countdown timer will turn off and the transmitter will play a melody.)
NOTE: The Remote Start Unit will not start the vehicle if any one of the following conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. The optional remote start enable toggle is switched to the
“OFF”
position. (If installed)
4. The gear selector is in any gear other then “PARK” or “NEUTRAL”.
PROGRAMMABLE SAFETY START (Child safety mode)
By default, your Silencer remote starter is programmed to start/stop after pressing the button 1 time. This default
setting can be re-programmed to require 2 presses of the button to remote start/stop the vehicle. This setting is known
as “Child Safety Mode”.
Contact your installer to reprogram this feature if needed.
B. OPERATE THE VEHICLE WHILE RUNNING FROM THE REMOTE START
To operate the vehicle while the engine is running from the remote start,
1. Insert the ignition key and turn it to
“ON”
(not the start) position.
2. Press the brake pedal.
Note:
If the brake pedal is pressed before the key is in the
“ON”
position, the engine will shut down.
C. TEMPORARY STOP FEATURE
This feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful
for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running
and the climate control on.
1. Before turning off the engine, press the button once on the transmitter and the LED indicator will flash
3 times to confirm enter.
2. Turn the ignition key to
“OFF”
position. (The engine will stay running.)
3. The engine will run until the pre-programmed time has elapsed or shutdown input is received.
