Operating manual - English
TARGA 2000
16
Copyright Silca 1999
6
REGULATION AND USE OF THE MACHINE
The cutting tool on the TARGA 2000 is used to cut the key blanks and must be periodically checked
and replaced. Periodically check the key-cutting machine settings, to ensure perfect machine
efficiency.
6.1
Calibration for bit/double bit keys
The TARGA 2000 key-cutting machine requires two types of calibration:
axis
and
depth
.
Axis calibration for bit/double bit keys
Axis calibration is regulation of the cutting spaces (fig. 12).
The axis setting for the TARGA 2000 is fixed and is established on assembly in our workshops.
Fig. 12
Depth calibration:
Depth calibration is regulation of the depths of the cuts (fig. 12).
Proceed as follows:
1) Disconnect the machine from the mains.
2) Place the adjusting pins (S) (provided) on the clamps (fig. 13).
3) Lock the clamps in the horizontal position by means of the knob (D2).
4) Raise the carriage and take the setting pins into contact with the tracer point and cutting tool
(fig. 13).
5) Turn the cutting tool anticlockwise manually and check that it skims the adjusting pins in several
places.
6) If necessary,
regulate
the cutting depth by means of the tracer point, as described below:
a) Turn the nut (I2) clockwise to advance the tracer point.
b) Turn the nut (I2) anticlockwise to move the tracer point back.
c) Repeat these operations until the cutting tool skims the setting pins in several points.
Fig. 13
cutting space
cutting
depth
S
D2
S
I2
