Operating manual - English
TARGA 2000
14
Copyright Silca 1999
5
MACHINE INSTALLATION AND PREPARATION
TARGA 2000 key-cutting machine can be installed by the purchaser and does not require any
special skills. However, some checks and preparation for use are advisable.
5.1
Separate parts
The detachable parts of the machine are packed separately and must be fitted to the TARGA 2000
by the operator, as follows:
Clamp carriage
Place the clamp carriage into its seating and tighten the carriage release knobs (D1) (fig. 8).
Carriage lever handle
Screw the handle (A) onto the carriage lever (fig. 8).
Chippings tray
Insert the chippings tray (C) into the special seat (fig. 8).
Power cable
Connect the safety device (X) to the key-cutting machine with the power cable then connect the
free end of the cable to the power mains (fig. 9).
Fig. 8
5.2
Connection to the mains
It is extremely important for the operator’s safety to ensure that the key-cutting machine is
connected to the power mains with the right voltage and by means of a properly earthed differential
switch.
Fig. 9
5.3
Checking for damage
The TARGA 2000 is solid and compact and will not normally damage if transport, unpacking and
installation have all been carried out according to the instructions in this manual.
However, it is always advisable to check that the machine has not suffered any damage.
D
D1
A
C
power mains
power
cable
X
