Silca Delta 2000 FO, Operating Manual

Page: 9 / 25

Operating manual - English DELTA 2000 FO
Copyright Silca 1998 5
3 MACHINE DESCRIPTION
DELTA 2000 FO is a professional key-cutting machine for FORD® and JAGUAR® car keys. The
machine comprises the following main parts:
S
AFETY DEVICE
The device is connected to a power plug with a differential switch. power the key-cutting machine
by pressing the switch (X1)
(fig. 6) .
The warning light (X2) illuminates to indicate voltage in the plug (X3).
WARNING: Switch (X1) is electromagnetic, in the event of a power failure it goes out automatically. When
electricity is restored it must be reset manually to power the machine again by means of the plug
(X3).
Fig. 6
M
ASTER SWITCH
(
D
)
The motor and brush starting button (D) is placed on the left side of the DELTA 2000 FO key-cutting
machine.
ATTENTION: the switch is constantly illuminated to indicate that the machine is live.
M
OTOR
The DELTA 2000 FO has a direct drive motor. The transmission unit comprises the motor, cutter and
brush and is protected by a single cover (H).
M
OBILE UNIT
The mobile unit comprises a carriage (B) to which is fitted the coded spacing device and a key-locking
clamp with a coded angle device.
The carriage is fitted to the translation shaft and is moved manually by the operator.
It has been designed to avoid the accumulation of cutting dust or chippings.
The key-cutting machine has an inclined table which allows the chippings to collect in the special tray
(C) placed under the carriage and easily removable for thorough cleaning.
• Brush (J)
The brush is used to eliminate burrs caused by the cutting process and is made of safe materials.
• Cutting tool (G)
The cutting tool is the part of the DELTA 2000 FO machine which cuts the key blank. The tool is in HSS
super rapid steel and is protected by a special cover (H) to ensure safe operation.
• Tracer point (F)
The tracer point is housed on the left-hand side of the machine base. Its depth settings are easily
regulated with the ring nut (F2).
• Coded angle device
The device comprises:
-
tip stop (A2) connected directly to the angle setting device;
- idle bush (A) for centring and locking the key.
• Key-locking grub screw (A1)
The key is secured by means of a grub screw which ensures perfect grip on the key.
• Coded spacing device
The code device comprises a knob (E2) to activate a graduated slide which determines the position of
the various cuts.
X
X1
X2
X3