Operating manual - English
DELTA 2000 AY
Copyright Silca 1 998
13
6.3
Cutting operations
WARNING:
to work in complete safety, pay special attention to the following recommendations:
•
Always work with dry hands.
•
Check that the machine is properly earthed.
•
Use the protective goggles, even if the cutting tool is fitted with a protective shield.
•
Start the motor only when all the operations with the carriage have been carried out (securing
keys, etc.).
•
Keep hands away from the cutting tool when in motion.
6.4
Key cutting
P
LACING
KEYS
INTO
CLAMP
Place the key blank into the clamp, pushing against the side of the tip stop (A3), and secure by turning the knob
(A) (Fig. 13).
Fig. 13
6.5
Code key-cutting
N.B.: ABLOY keys can feature two types of cut which differ only in the distance between the
first cut and the tip of the key. This distance can be 3 or 5 mm (fig. 10-A). To cut keys with 3 mm
use mark 3 on the locator (Fig. 11) as a reference for positioning the key. For 5 mm keys, use
mark 5.
To code cut a key blank proceed as follows:
1) set the cutting position on the space code device by means of knob (E2) (fig. 13). Exert pressure on
knob (A) to turn the rotating clamp (A1) until the code for the inclinations marked on the drum (A5) is
aligned with the indicator (A4).
2) activate the machine by pressing the motor/brush start switch (D) (fig. 5, pag. 4).
3) move the carriage towards the cutting tool, making sure that the tracer point slides right into the notch
on the locator (fig. 13). Make the cut and pull back the carriage.
4) go on to the following position and repeat the cutting operation with the corresponding code, and so
on until the key has been cut.
5) pull the carriage back, turn off the machine, loosen the clamp (A1) and remove the key.
key blank
locator
E2
A
E2
A1
A5
A4
A3
A1
Summary of Contents for Delta 2000 AY
Page 1: ...D413450XA vers 3 0 Operating manual EN...
Page 4: ......
