Siko 6007422, Translation Of The Original Installation Instructions

Page: 38 / 64

AG02
Installation English
AG02 · Date 31.10.2012 · Art. No. 82270 · Mod. status 354/12
38
Risk of position value loss and nonbraked actuator
Please respect the following recommendations. Unless the driving shaft
risks to slide or be destroyed:
Version with clamping ring:
` screw's fastening torque: min. 5 Nm
` recommended shaft diameter: ø14
f8
Version with keyway:
`
min. key length: A3x3x16 mm (not included in the supply)
`
recommended key material: C45K (1.1192)
`
recommended shaft diameter: ø10
f8
Preparing mounting ( Fig. 1 , Fig. 2 , Fig. 3 ):
1. Make bore (øD) with distance (L1) to the driving shaft
2
.
2. Observe max. length (L2) and diameter (ød) of shaft 2 .
3. Untighten the M6 screw in the torque support 1 and M6 screw in the
clamping ring
3
respectively grub screw
4
.
Mounting ( Fig. 1 , Fig. 2 , Fig. 3 , Fig. 4 ):
1. Slide the actuator on the shaft 2 until the torque support has
reached the stopper
1
. You may slightly adjust the torque support to
the installation conditions via a long hole.
2. Tighten the clamp ring screw 3 by applying 5 Nm, or headless pin 4 .
3. Fasten the screw for the torque support
1
with max. 2 Nm.








Fig. 1: Mounting dimensions
dim. øD ø13 - ø14
dim. L1 106,7
dim. L2 40 (i=55,3)
50 (i=62,2 / i=135,8)
dim. ød
suggestion
ø14
f8
(clamp ring)
ø10
f8
(feather key groove)
Tab. 1: Mounting dimensions
CAUTION