3
1.
Turn OFF the power to your computer and any
other connected peripheral devices.
2.
Unplug the power cord from the back of the
computer.
3.
Remove your computer
’
s cover.
4.
Remove the slot bracket from an available PCI slot.
5.
To install the card, carefully align the card's bus
connector with the selected PCI slot on the
motherboard. Push the board down firmly, but
gently, until it is well seated.
6.
Replace the slot bracket's holding screw to secure
the card.
7.
If needed, connect the HDD LED pins to monitor
HDD activity from the front panel of your chassis.
8.
Replace the computer cover and reconnect the power
cord.
Driver Installation
This section provides information on how to install the
SATA II-150 PCI i/e
drivers for the following operating
systems.
Windows 2000
New Windows 2000 Installation
A new installation of Windows 2000 requires a floppy
disk for the driver installation. To make this floppy disk,
copy the
contents
of the
Floppy
folder, found on the
driver CD, onto a blank floppy disk then follow the
directions below.
1.
Install the board and follow the Microsoft
procedures to install Windows 2000 accordingly.
