background image

eSATA II-150 PCI i/e  is a trademark of SIIG, Inc.

SIIG and SIIG logo are registered trademarks of SIIG, Inc.  Microsoft and Windows are

registered trademarks of Microsoft Corporation.  Other names used in publication are for identification

only and may be trademarks of their respective companies.

May, 2006                       Copyright 

©

2006 by SIIG, Inc. All rights reserved.

PRODUCT NAME

eSATA II-150 PCI i/e

FCC RULES: TESTED TO COMPLY WITH FCC PART 15, CLASS
B OPERATING ENVIRONMENT: FOR HOME OR OFFICE USE

FCC COMPLIANCE STATEMENT:

This device  complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:  (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

THE PARTY RESPONSIBLE FOR PRODUCT COMPLIANCE

SIIG, Inc.
6078 Stewart Ave.
Fremont, CA  94538-3152

About SIIG, Inc.

Founded in 1985, SIIG, Inc. is a leading computer upgrade manufacturer

of I/O connectivity products, including PCI & ISA serial and parallel

ports, USB, Serial ATA & UltraATA controllers, FireWire (1394a/b),

Networking, Sound Cards, and other accessories.  SIIG is the premier

one-stop source of upgrades.
SIIG products offer comprehensive user manuals, many user-friendly

features, and are backed by an extensive manufacturer warranty.

High-quality control standards are evident by the overall ease of

installation and compatibility of our products, as well as one of the

lowest defective return rates in the industry.  SIIG products can be

found in computer retail stores, mail order catalogs, and e-commerce

sites in the Americas and the UK, as well as through major

distributors, system integrators, and VARs.

Summary of Contents for SC-SA1012-S1









Reviews: