INSTALLATION INSTRUCTIONS
PowerForm Area & Flood
PN:443560815050
Rev: C
SlipFitter (SF)
Page 6 of 6
Signify Canada Ltd./Signify Canada Ltée.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
Signify North America Corporation
200 Franklin Square Drive
Somerset N.J. 08873, USA
© 2018 Signify Holding. All rights reserved. This document contains information relating to the product portfolio
of Signify which information may be subject to change. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability for any action in reliance thereon is
disclaimed. The information presented in this document is not intended as any commercial offer and does not
form part of any quotation or contract. All trademarks are owned by Signify Holding or their respective owners.
www.gardcolighting.com
SF
-
SlipFitter Arm Mounted on HORIZONTAL Mast Arm requires a
3/8
-
16”
x 3
-
1/2
bolt thru the Mast Arm pipe.
(Cont
’
d)
AIMING INSTRUCTIONS
STEP 1:
To adjust the angle, loosen the (1)
1/2
–
13
x
2”
Hex
Head Bolt located in Slipfitter Arm. (Do not remove
bolt.) Loosen only enough to allow rotation on cast
teeth.
STEP 2:
The angle of the luminaire can be adjusted up or
down in 4° increments.
STEP 3:
Using the degree indicators, shown as a guide, ro-
tate the luminaire to the desired position and re-
tighten the bolt loosened in Step 1 to approx.
75 ft.
-
lbs.
STEP 4:
Energize luminaire to test installation.
NOTE: Luminaires with Photo Control must be
restricted to +/
-
45º from horizontal aim.
1/2
-
13”
Hex Head
bolt
SlipFitter
Arm
