INSTALLATION INSTRUCTIONS
PowerForm Area & Flood
PN:443560815050
Rev: C
SlipFitter (SF)
Page 4 of 6
Signify Canada Ltd./Signify Canada Ltée.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
Signify North America Corporation
200 Franklin Square Drive
Somerset N.J. 08873, USA
© 2018 Signify Holding. All rights reserved. This document contains information relating to the product portfolio
of Signify which information may be subject to change. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability for any action in reliance thereon is
disclaimed. The information presented in this document is not intended as any commercial offer and does not
form part of any quotation or contract. All trademarks are owned by Signify Holding or their respective owners.
www.gardcolighting.com
CAUTION:
Philips Lighting assumes no responsibility for the structural integrity of the Mast Arm.
The EPA value of the luminaire CANNOT exceed the maximum loading value of the Mast Arm.
SlipFitter Arm
Mast Arm (by others)
STEP 1:
Slip the SlipFitter Arm onto the Mast Arm. Fig. 1
STEP 2:
Level luminaire by adjusting engagement of the
(4)
1/2
-
13”
Allen
Socket Head bolts and tighten to ap-
prox. 43 ft.
-
lbs. Fig. 2
STEP 3
After making sure the luminaire is leveled to the
desired orientation, use the
13/32”
holes of the
SlipFitter Arm to drill a
13/32”
hole through the
Mast Arm pipe. Fig. 3
STEP 4
Remove the SlipFitter Arm and luminaire from the
Mast Arm. Fig. 4
STEP 5
To access wire splice area, remove (2) #8
-
32 Splice
Cover screws, splice cover, and gasket. Fig. 5
STEP 6:
Route the supply wires through the Mast Arm. Se-
cure the supply wires to keep from sliding back
down the Mast Arm.
Route the wires through SlipFitter Arm into splice
area.
Fig. 1
Fig. 2
(4) 1/2
-
13”
Allen Socket
Head bolts
Fig. 3
Drill a
13/32”
hole
through the Mast
Fig. 4
Mast Arm
SF
-
SlipFitter Arm Mounted on HORIZONTAL Mast Arm requires a
3/8
-
16”
x 3
-
1/2 bolt thru the
Mast Arm pipe.
