AFTER SALES SUPPORT
1300 777 137
MODEL: EA2258 PRODUCT CODE: 709435 07/2022
12
INSTRUCTIONS (CONT.)
3. To ensure accuracy, hold the Laser Range
Finder with a firm grip and keep it steady till
the measurement is displayed.
4. The default unit of measurement is M
(Metres). To change the unit of measurement
to Y (Yards), hold down the MODE button. To
switch between the two units keep holding
down the MODE button. Once the unit of
measurement desired is selected, release
the MODE button.
WARNING: Please always pass your hand through the wrist strap prior to
gripping the Laser Range Finder to avoid it from dropping and getting
damaged.
NOTE: If no distance is displayed on the lens display, there is a possibility that
the object is not in the measuring range of 5 to 1000m. In this case, you will
need to retarget and measure.
NOTE: The Laser Range Finder will shut down automatically if it is not used
within 15 seconds of turning it ON.
Scanning Mode
This mode is an extension of the Ranging Mode,
so you need to remain in Ranging Mode to
access the Scanning Mode. It is very convenient
as it allows to measure distance to multiple
landmarks (within the Laser Range Finder
measuring range) by gradually moving the
device. There is no need to point and trigger
each target or landmark one at a time, like the
Ranging Mode. Scanning Mode takes all the
finger work out for you so that as you pass over
stationary or moving targets, you’ll see the
distances updated on the display.
Fig. 3.1
Fig. 2.2
