Wireless Receiver
1. Receiver Antenna
– receives signals from the camera(s). Adjust the antenna to vertical position for
better signal reception.
2. DC 9V Power Input
– Connect the
included DC 9V power adaptor to power
the receiver.
3. A/V Out Port
– Connect the included
A/V cable to view video on a TV or
monitor, or record to a VCR/DVR.
4. Alarm Volume Knob
– Turn the knob
to increase or decrease the volume of
the audio alarm.
5. Indication LEDs
– Indicates the
status of the system. There are 6
indication LEDs:
MANUAL
: Indicates manual switching
mode between activated cameras.
AUTO
: Indicates automatic switching
mode between activated cameras.
M
: Indicates manual recording mode.
A
: Indicates auto recording mode. In this
mode receiver starts to record when there is motion detection in camera side.
NEW
: Indicates new recorded video.
FULL
: Indicates that the SD card is full of memory. It is only available when Overwrite is disabled.
6. Operation Buttons
– Use these buttons for receiver operation.
(Channel) M
– Press the button to manually switch between all activated cameras. Once the button is
pressed, the indication LED
MANUAL
will be on.
(Channel) A
– Press the button to view cameras in automatic switching mode. Once the button is
pressed, the indication LED
AUTO
will be on.
(Record) M
– Press the button to start recording, press it again to stop recording. In this manual
recording mode, the indication LED
M
will be on.
(Record) A
– Press the button to switch the system to automatic recording mode. In auto recording
mode, the indication LED
A
will be on and the receiver starts recording when motion detected by a
camera. The recording time can be set to 15s or 30s. Press the button again to cancel automatic
recording.
2
Quad
– Press
Quad
button to view the images in quad mode. Press
Quad
or
(Channel) A
buttons to
exit from quad mode to automatic switching mode, press
(Channel) M
button to exit from quad to
manual switching mode.
