6
8350-1 Temperature Transmitter
Calibrate Menu
Display
(Factory settings shown)
Description
Temp Units:
°C >
Select Temperature units:
°
C or
°
F.
Set:
Temperature
Provides a maximum 20
°
C offset to match 8350 to external reference.
Enter “-999” to restore the original Factory calibration value.
Changes to this setting will become effective when the display exits the Calibrate menu.
Loop Range: °C
0.0
→
100.0
>
Check the 2350 Sensor instructions for the range capability of your sensor.
Be sure to modify this setting if you change the Temperature Units.
Output Mode:
Low >
Select the desired mode of operation for the Open Collector output. Options available are Off,
Low, High or Pulse. The signal may be disabled (Off) if not used.
Output Setpnt:
25.0
°C
>
In Low or High Mode, the Open Collector output will be activated when the temperature
reaches this value. Be sure to modify this setting if you change the Temperature Units.
Output Hys:
°C
>
The Open Collector output will be de-energized at Setpoint ± Hysteresis, depending on High
or Low Setpoint selection.
Output Range:
25.0-45.0 >
If the output is in PULSE mode, set the start and end point of the range and also set the
maximum pulse rate. (The maximum PULSE rate setting is 400 pulses per minute.)
The combined Output Range and Pulse rate settings shown here indicate:
"Start pulsing when the process value is 25° and increase the pulse rate up to the maximum
of 120 pulses per minute when the process value reaches 45°"
Output PlsRate:
120 Pulses/Min
>
Last CAL:
2-10-09
Use this “note pad” to record important dates, such as annual recerti
fi
cation or scheduled
maintenance.
