SignaMax 065-7851, User Manual

Page: 23 / 365

Publication date:Oct., 2012
Revision A2
21
•
TP Port and Cable Installation
⇒
In the switch, TP port supports MDI/MDI-X auto-crossover, so both types of
cable, straight-through and crossed-over can be used. It means you do not have
to tell from them, just plug it.
⇒
Use Cat. 5 grade RJ-45 TP cable to connect to a TP port of the switch and the
other end is connected to a network-aware device such as a workstation or a
server.
⇒
Repeat the above steps, as needed, for each RJ-45 port to be connected to a
Gigabit 10/100/1000 TP device.
Now, you can start having the switch in operation.
••••
AC Power On ( For SIGNAMAX 065-7851 L2 )
The switch supports 100-240 VAC, 50-60 Hz power supply. The power
supply will automatically convert the local AC power source to DC power. It does not
matter whether any connection plugged into the switch or not when power on, even
modules as well. After the power is on, all LED indicators will light up immediately
and then all off except the power LED still keeps on. This represents a reset of the
system.
DC Power installation (For SIGNAMAX 065-7851 L2 D)
Power requirement 48 VDC (36~72VDC)
You have to add DC power through the removable terminal block from external DC
power source.
Wiring the Power Input
1. Insert the positive and negative wires into the + and – terminal Block
2. Tighten the wire-clamp screw to prevent the DC wires from being
loosened.
3. Insert the Ground wire into the “GND” terminal block
Note: The Suitable working voltage is from 36 to 72 VDC.
••••
Firmware Loading
After resetting, the bootloader will load the firmware into the memory. It will
take about 30 seconds, after that, the switch will flash all the LED once and
automatically performs self-test and is in ready state.
Fig. 2-1-2 Insert the positive and negative wires into the terminal block