3
SignalFire Telemetry
Rev 2.0
Connections and Components
Radio LEDs
-
The Radio TX LED (
green
) flashes each time a radio packet is sent. This LED will blink rapidly while
searching for the radio network.
-
The Radio RX LED (
red
) blinks on each received radio packet.
Status LEDs
-
The Active LED (
green
) will blink at boot up and will blink rapidly when the sensor is being powered and
read.
-
The ERROR LED (
red
) will blink to indicate an error condition.
Solar Battery Connector
-
Run the power cable from the solar system through the cord grip and plug into this connector. Tighten
cord grip to ensure water tight seal
Configuration Port
-
Connect a SignalFire USB-Serial-4PIN cable to this port to configure the Repeater with the SignalFire
ToolKit software
Radio LEDs
Solar Battery Connector
Config Port
Status LEDs
