Rev 1.0
SignalFire Telemetry
5
Status LED
The DIN Gateway v2 has a Status LED that blinks as follows:
STATUS LED
Description
Slow Flash (3 second pause)
System is running and has one or more nodes on network
Fast Flash (0.5 second pause)
System is running but no nodes found on network
Solid On
System Fault needs service or rescue bootload
Operation
The DIN Gateway v2 supports all remote SignalFire nodes making all remote sensor data
available in Modbus format.
The register data from remote sensor nodes is available by requesting the remote node’s Modbus
slave ID and register address from that node’s register map. The gateway will respond with the most
recent copy of the data from the remote node. The gateway will automatically time-out data from a
remote node it stops receiving data for.
Setup
The DIN Gateway v2 requires an initial configuration over RS-232 using the SignalFire Toolkit. Connect
a USB-Serial cable (purchased from SignalFire) between a computer and the Gateway’s DB9 port.
The following items must be configured to set up a SignalFire network:
-
Radio Network
-
Radio Network Group
-
Encryption Key
