CCP 621
C-DIAS PROSESSOR MODULE
Page 24
27.03.2020
11.2 Shielding
The wiring for the CAN bus, Ethernet and VARAN bus must be shielded. The low-ohm
shielding is either connected at the entry to the control cabinet or directly before the
CCP 621 processor module over a large surface (cable grommets, grounding clamps)!
Noise signals can therefore be prevented from reaching the electronics and affecting the
function.
11.3 ESD Protection
Before any device is connected to or disconnected from the CCP 621, the potential with
ground must be equalized (by touching the control cabinet or earth terminal). This will allow
the dissipation of electrostatic loads (caused by clothing/shoes).
Summary of Contents for CCP 621
Page 10: ...CCP 621 C DIAS PROSESSOR MODULE Page 8 27 03 2020 2 Mechanical Dimensions...
Page 12: ...CCP 621 C DIAS PROSESSOR MODULE Page 10 27 03 2020 4 Connector Layout...
Page 21: ...C DIAS PROCESSOR MODULE CCP 621 27 03 2020 Page 19 9 Configuration of the Process Module...
Page 28: ...CCP 621 C DIAS PROSESSOR MODULE Page 26 27 03 2020 13 Process Diagram...