Sigma Silver 50, Use And Maintenance Instruction Manual

Page: 9 / 23

SL-50 SL-60 MIXERS 9 of 23
Modality for granting the warranty
If the customer finds defects in the mixer, he must immediately inform the supplier, who will carry out a quick
analysis of the lack of compliance and will establish the intervention mode with the customer.
The customer must provide the needed time and opportunity to carry out modifications, improvements,
repairs or the supply of spare parts which the supplier deems reasonably necessary. If this does not occur,
the supplier will not be held liable.
Parts subject to wear
Some components are scaled for a life duration far longer than that of normal mixer use during the time of its
warranty. Breakage or malfunctioning of these pieces depends on their use. They are therefore considered
parts subject to wear and are not included in the warranty, unless they manifest evident defects in the parts
or machinery.
The parts subject to wear are: transmission belts, motors, bearings and bowl.
INSTRUCTIONS FOR USE.
The mixer is provided with a master switch on the right side. It is controlled by one of the front
panels shown below.
The first panel has a manual timer with a selector for inversion of the rotation direction of the bowl and one
for the exclusion of the timers in the event of a failure. There are start and stop switches on the equipment to
start and stop the mixer.
The second and third panel, besides the selector inverting the rotation direction of the bowl and the one
excluding the timers in the event of a failure, also has an electromechanical emergency button which
immediately stops the mixer wherever it is.
The exclusively digital timers are adjusted by pressing the select key and setting the time by means of the +
and - keys. Having set the time of the first speed, press the select key to set the time on the second timer.
When the times have been set, press select once again to confirm the selection and to start work with the
mixer.
ATTENTION: The grid must be down for the mixer to work. Otherwise the safety system will block its
functioning.
Check the correct rotation direction of the bowl (clockwise, according to the arrow). If incorrect,
contact a qualified electrician.