SL-50 SL-60 MIXERS
7 of 23
Use the required P.P.E.
VERSION WITH SHIP ATTACHMENT:
Lifting standards of the mixer without pallet.
Due to its instability , the mixer must be handled with a suitably-sturdy strap, having
it pass below the head, as in the figure at the left.
Before lifting, stand the grid up vertically to avoid interference with the lifting strap.
Make sure the lifting equipment is adequate for the load.
Act on an empty area, and during movement, always keep the load as close to the
ground as possible.
Use the required P.P.E.
The mixer inclines by 8-10 degrees when lifted.
Transport standards of the mixer with wheels.
Act on an empty area, and on a floor with adequate sturdiness
(concrete, tiles, etc. as long as it has load capacity > 20 kgcm
2
),
smooth, even and without any differences in level.
Use the required P.P.E.
Fully tighten support "A", the mixer will rest completely on the wheels.
Push the fixer as shown in figure.
Once the wanted location is reached, tighten the two supports "A"
until the front wheels are lifted from the ground.
ATTENTION.
Do not make the mixer function only on wheels,
always tighten the two supports “A” until the wheels are fully
lifted.
Summary of Contents for Silver 50
Page 16: ...SL 50 SL 60 MIXERS 16 of 23 SL 50 STANDARD VERSION SPARE PARTS LIST...
Page 18: ...SL 50 SL 60 MIXERS 18 of 23 SL 50 GREEN LINE VERSION SPARE PARTS LIST...
Page 20: ...SL 50 SL 60 MIXERS 20 of 23 ELECTRICAL LAYOUT STANDARD VERSION...
Page 21: ...SL 50 SL 60 MIXERS 21 of 23 ELECTRICAL LAYOUT GREEN LINE VERSION...
