![background image](http://html1.mh-extra.com/html/sigma/134226/134226_operating-manual_1267882037.webp)
2-16KC
Using the Centrifuge
Version 03/2010, Rev. 1.7 of 27/01/2012
37
Translation of the original operating manual
Creation of the curves for variable accelerations and
decelerations
In the configuration mode, select the field "Curves" and confirm
the selection. The curve overview will be displayed.
Select the time display and confirm the selection.
Enter the desired time for interval no. 1 and confirm the entry. The
display for internal no. 2 will be displayed simultaneously.
Fig. 6.18: Time value input into interval no. 1
Select the speed field "SPEED" and confirm the selection.
Select the speed value and confirm the selection. The curve that
is created will be displayed together with the maximum curve
speed.
Fig. 6.19: Time value input into interval no. 2
Activate the time display of the second interval and enter the
desired time. The extended curve will be displayed.
Fig. 6.20: Extended curve
Select the speed field "SPEED" and enter a speed value. Confirm
the entry.
You can enter up to 10 intervals in this manner.
Save the curve under a curve number between 20 and 29
together with the current operating parameters.
Select “EXIT” and quit the curve mode by confirming the entry.
Only acceleration curves are programmed. The corresponding
deceleration curves are generated by reflection.
If the curve speed of an interval exceeds the set speed in the
operating mode, a dialog box will pop up.
Fig. 6.21: Dialog box concerning the curve speed