SIGLENT SPD3303C Series, Quick Start Manual

Page: 18 / 33

16
Quick Start
CH1/CH2 Independent Output
Instruction: CH1 and CH2 are working in independent mode and insulated from the ground.
Output ratings 0~32V / 0~3.2A
Operation steps
1.
Make sure that parallel/series mode is off.
2.
Connect load to the positive and negative terminals of CH1/CH2.
3.
Set the voltage (current) value of CH1/CH2: Firstly, press V (or A ) to select the voltage (current)
parameter needed to modify. Then revolve the multi-function knob to set the wanted value (You
could press FINE to make accurate adjusting).
Coarse adjusting: 0.1V or 0.1A each step.
Fine adjusting: the least precision each step.
4.
Open output: Press ON/OFF button to turn on the output, the channel works in CC or CV mode
and its indicator light gets lighted immediately.
Set the OCP mode
Under the condition of the corresponding channel closed, press the A Button longer to enter/exit the
OCP mode. In OCP mode, you can set the overcurrent protection value. If the output current
reaches the overcurrent protection value, the channel output will be closed.