SDG5000 User Manual 24
Table2- 1 Menu Explanations of Sine Waveform
To Set the Output Frequency/Period
1. Press Waveforms →Sine→ Frequency, to set the frequency parameter.
The frequency shown on the screen when the instrument is powered is
the default value or the set value beforehand. When setting the function,
if the current value is valid for the new waveform, it will be used
sequentially. If you want to set the period for the waveform, press
Frequency/Period button again, to switch to the period parameter (the
current operation is displayed in inverse color).
2. Input the desired frequency.
Use the keypad to input the parameter value directly, and press the
corresponding button to select the parameter unit. Or you can use the
direction button to select the digit you want to edit, and then use the knob
to change its value.
Function
menu
Setting
Explanations
Frequency/
Period
Set the signal frequency or period;
The current parameter will be switched at
a second press.
Amplitude/
HighLevel
Set the signal amplitude or high level;
The current parameter will be switched at
a second press.
Offset/
LowLevel
Set the signal offset or low level;
The current parameter will be switched at
a second press.
Phase
Set the phase of the signal;
Summary of Contents for SDG5000 series
