41110590
Rev 6.1
January 28, 2019
33
5. Last Gasp Configuration
This section enumerates the Last Gasp configuration commands that can be used with the GL7600.
Note:
This section is only available on the GL7600.
5.1.
+LASTGASP Command: Last Gasp Status
+LASTGASP Command: Last Gasp Status
Test command
Syntax
AT+LASTGASP
=?
Response
+LASTGASP: (0,1)
OK
Read command
Syntax
AT+LASTGASP?
Response
+LASTGASP: <Firmware version>
,
<scv>
,
<sv>, <lcsv>, <lrs>, <srs>, <urs>
OK
Write command
Syntax
AT+LASTGASP=
<n>
Response
OK
Parameters
<Firmware version>
Firmware version (information text)
<scv>
Super capacitor voltage, in volts. Dot is used as a decimal separator
<sv>
Supply voltage, in volts. Dot is used as a decimal separator
<lcsv>
Last computed supercap, in farads. Dot is used as a decimal separator. If the
value is not known, this parameter returns 0.0 (current value).
<lrs>
Last gasp response status
0
Disabled
1
Enabled
<srs>
SMS response status
0
Disabled
1
Enabled
<urs>
UDP response status
0
Disabled
1
Enabled
<n>
Enable/disable the last gasp feature
0
Last gasp disabled
1
Last gasp enabled
