41110590
Rev 6.1
January 28, 2019
23
Product Technical Specification and
User Guide
Interfaces/Peripherals
The RS232-CTS and RS232-RTS signals are not used in this configuration. Sierra Wireless
recommends the use of hardware flow control, but if not needed, the AT commands
AT&K0
and
AT&W0
can be used to disable the flow control function on the embedded module.
Note:
A 2-wire serial link implementation is not possible if
AT+KSLEEP=0
.
For more information about AT commands applicable to the GL7500, please refer to document [3]
AirPrime HL7588 AT Commands Interface Guide; for more information about AT commands
applicable to the GL7600, refer to the commands marked as supported by HL7692 in document [4]
AirPrime HL76xx AT Commands Interface Guide.
2.2.2.
Micro USB Connector
The GL7x00 supports a high-speed USB 2.0 interface at 480 Mbit/s which could be connected directly
to a PC USB port.
The signals on the micro USB connector are as follows:
•
Vin, 5V (pin 1)
•
D- (pin 2)
•
D+ (pin 3)
•
GND (pin 4)
Note:
The Micro USB connector is only used for data transfer; the GL7x00 cannot be supplied with
voltage via this interface.
Figure 10.
USB Signals on the Micro USB Connector
2.2.2.1.
Pin Description
Refer to the following table for the USB pin description.
Table 13.
USB Pin Description
Pin Number
Signal
Description
1
Vin
5V, voltage input
2
D+
Universal serial bus data positive
3
D-
Universal serial bus data negative
Micro USB Connector
