en
Cleaning and maintenance
32
5.
Put the service flap back on, lock it
into place and close it.
Note:
To prevent unused detergent
from flowing straight into the drain
during the next wash: Pour 2 litre of
water into dispenser
II
and start the
Single spin
programme.
The drain hose at the siphon
is blocked
1.
Turn the programme selector to
$
Off
. Pull out the mains plug.
2.
Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3.
Clean the drain hose and siphon
connecting piece.
4.
Re-attach the drain hose and secure
the connection point using the hose
clamp.
Filter in the water supply is
blocked
1.
Release water pressure in the supply
hose:
a) Turn off the tap.
b) Select any programme (except
Rinse
and
Spin
).
c) Select the
A
Start/Reload
button. Allow the programme to
run for approx. 40 seconds.
d) Turn the programme selector to
$
Off
. The appliance is switched
off.
e) Pull out the mains plug.
2.
Clean the filters:
a) Disconnect the hose from the
tap.
Clean the filter with a small brush.
b) For standard and Aqua-Secure
models, clean the filter on the
rear of the appliance:
Disconnect the hose from the
rear of the appliance.
Use pliers to remove the filter and
then clean it.
3.
Connect the hose and check for
leaks.
Summary of Contents for WU P Series
Page 39: ...6 ...
