Positioning and connecting
en
15
Hose and cable lengths
■
Left-hand connection
■
Right-hand connection
*depending on the model
Tip:
The following are available from
specialist dealers/the after-sales
service:
■
An extension for Aqua-Stop or cold
water supply hose (approx. 2.50 m);
order no. WMZ2380, WZ10130,
CZ11350, Z7070X0
■
A longer supply hose (approx.
2.20 m) for standard model
Water inlet
:
Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Notes
■
Only operate the appliance using
cold mains water.
■
Do not connect the appliance to the
mixer tap of an unpressurised hot-
water boiler.
■
Do not use a used supply hose. Only
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
■
Do not kink or squash the water
supply hose.
■
Do not alter (shorten, cut through)
the water supply hose (otherwise its
strength is no longer guaranteed).
■
Only tighten the screw connections
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may become
damaged.
Optimum water pressure in the supply
network
At least
0.1 MPa (1 bar)
Maximum
1 MPa (10 bar)
Notes
■
When the tap is open, the water flow
rate is at least 8 l/min.
■
If the water pressure is higher than
this, a pressure-reducing valve must
be installed.
Connection
Connect the water supply hose to the
tap (26.4 mm = ¾"):
Note:
Turn on the tap carefully,
checking the leak tightness of the
connection points. The screw
connection is under mains water
pressure.
PD[FP
PD[FP
Summary of Contents for WU P Series
Page 39: ...6 ...
