Faults and what to do about them.
en
25
3
Faults and what to do
about them.
Faults and what to do about them.
Emergency release
e.g. in the event of a power cut
The programme continues running
when the power supply is restored.
However, if the laundry has to be
removed, the washing machine door
can be opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot
detergent solution and laundry.
If possible, leave it to cool down.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is rotating.
Do not reach into the drum while it is
rotating. Wait until the drum has
stopped rotating.
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the washing machine door
if water can be seen through the glass.
1.
Turn the programme selector to
Off
.
Remove the mains plug.
2.
Drain the water.
Pull down emergency release with a
tool and release.
The washing machine door can then be
opened.
Information on the display panel
Display
Cause/Remedy
YES
The washing machine door is unlocked. It is possible to add laundry.
NO
■
Due to the high temperature in the drum, the washing machine door cannot
be opened. Wait until the temperature drops.
■
Due to the high level of water in the drum, the washing machine door can-
not be opened. Drain the water e.g. select the
0
p
Spin/
Empty
pro-
gramme (if only a drain cycle is required, set rpm (spin speed) to - - -).
E:17
Turn on tap fully, supply hose kinked/jammed; water pressure too low, clean fil-
ter
~
Page 24
E:18
Drain pump blocked; clean the drain pump
~
Page 23
Drainage hose/outlet pipe blocked; clean drainage hose on the siphon
~
Page 24
E:23
Water in the base trough, appliance leaking. Call after-sales service.
~
Page 28
w
If childproof lock is active, deactivate it
~
Page 19
x
~
flashes: Too much foam detected?
~
Page 26