en
Positioning and connecting
48
Electrical connection
:
Warning
Danger of death!
There is a risk of electric shock if you
touch live components.
■
Never touch or hold the mains plug
with wet hands.
■
Only pull out the mains cable by the
plug and never by the cable, as this
could damage it.
■
Never unplug the mains plug during
operation.
Observe the following information and
ensure that:
Notes
■
The mains voltage and voltage
indicated on the washing machine
(rating plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
■
The washing machine is only
connected to an alternating current
supply via a properly installed
earthed socket.
■
The mains plug fits the socket.
■
The cable cross-section is adequate.
■
The earthing system is properly
installed.
■
The mains cable is only replaced by
a qualified electrician (if this is
necessary). Replacement mains
cables are available from customer
services.
■
No multiple plugs/couplings or
extension cables are used.
■
If an earth-leakage circuit breaker is
used, only a type which displays the
z
symbol is used.
Only this symbol guarantees
compliance with the currently
applicable regulations.
■
The mains plug can be accessed at
all times.
■
The mains cable is not kinked,
squashed, altered or cut through.
■
The mains cable does not come into
contact with heat sources.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from the test, run the first wash cycle
without
any laundry.
Notes
■
The washing machine
must be
correctlyinstalled
and
connected
.
(from
■
Never use a damaged machine.
Inform your customer services.
Preparatory work:
1.
Check the machine.
2.
Fill the
ß
and
i
/
ß
dispensers.
3.
Remove the protective film from the
control panel.
4.
Connect the mains plug.
5.
Turn the tap on.
Run the programme without laundry.
1.
Switch on the appliance.
2.
Close the door (do not load any
laundry).
3.
Set the
Drum clean
90 °C
programme.
4.
Open the detergent drawer.
5.
Pour approx. 1 litre of water into
compartment
À
Á
.
6.
Pour standard detergent into
compartment
À
Á
.
Note:
To prevent foaming, only use
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
designed for woollens or delicates.
7.
Close the detergent drawer.
8.
Press the
Ü
button.
9.
Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
