Siemens WM14UQ92GB, User Manual And Installation Instructions

Page: 53 / 68

Troubleshooting en
53
Fault Cause and troubleshooting
The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
▶ Clean the filters in the water inflow →
Page 49
.
The tap is turned off.
▶ Turn on the tap.
The water inlet hose is kinked or jammed.
▶ Ensure that the water inlet hose is not kinked or
jammed.
flashes. The automatic voltage control system detects an un-
authorised voltage under-usage.
▶
No remedial action possible.
Note: If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
Detergent dosage is too high.
▶
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
▶
Reduce the amount of detergent for the next wash-
ing cycle with the same load.
lights up. The temperature is too high.
▶
Wait until the temperature has dropped.
▶ → "Cancelling the programme", Page 42
Water level is too high.
▶
Start the Drain programme.
Laundry is caught in the door.
1.
Open the door again.
2.
Remove any trapped laundry.
3.
Close the door.
4.
Press to start the programme.
flashes. Door is not closed.
1.
Close the door.
2.
Press to start the programme.
All other error codes. Malfunction
▶ Call the after-sales service.
→
"Customer Service", Page 62