WT.050.130.000.UA.IM.1108
ACUTEC
™
35 SYSTEM
20
f. Position the electronic assembly as shown in Figure 3.2. Identify
DIP SWITCH BANKS A through D.
Figure 3.2 - Top View of Module Electronics Without Housing
g. Adjust the Receiver DIP switch functions as needed, by referring to
the Figure 3.3.
Switches can be set using the tip of a ball point pen or other tool with
a small point on one end. Switches are two-position, up indicating
“on” or a value of “1” and down indicating “off” or a value of “0”.
h. After adjusting the DIP switches, reassemble the receiver by re-
peating steps a through e in the reverse order, while observing the
following:
(1) When returning the electronic assembly to the housing, the LEDs
and displays must line up with the module enclosure windows.
(2) The bottom panel must be installed with the plastic clip at the
top of the receiver module.