instabus EIB
Technical Product Information
April 2006
Touch panel UP 588
5WG1 588-2AB01
Touch panel UP 588/11
5WG1 588-2AB11
Touch panel UP 588/21
5WG1 588-2AB21
Accessories: Design frame, anodised aluminium
5WG1 588-8AB01
Siemens AG
UP 588, 6 pages
Technical Manual
Automation and Drives Group
Electrical Installation Technology
©
Siemens AG 2006
Update: http://www.siemens.de/gamma
P.O.Box 10 09 53, D-93009 Regensburg
Subject to change without prior notice
2.3.1.4/5
D1
Once the all-purpose cover has been removed, the de-
sign frame can be detached and fully dismantled by
loosening the fixing screw B5.
Disconnecting the power supply terminal (Diagram 3
“B”)
-
To disconnect the power supply terminal C4, it must
first be pulled downwards out of the terminal com-
partment A1 via the latching mechanism A5. This can
be made easier by lifting the power supply terminal
C4 slightly using a narrow slotted screwdriver. It is in-
serted in the centre of the latching mechanism A5 be-
tween the power supply terminal C4 and the base of
the terminal compartment.
Removing the bus terminal (Diagram “A”)
-
The bus terminal (C3) is located in the left terminal
compartment. It consists of two sections (C3.2 and
C3.3), each with four terminal contacts. Care should
be taken not to damage the two test sockets (C3.1)
either by accidentally connecting them to the bus
conductor or with the screwdriver [when trying to
remove the bus terminal].
-
Carefully insert the screwdriver in the wire entry slot
of the grey section of the bus terminal (C3.3) and pull
the bus terminal (C3) out of the built-in device. When
the red section of the bus terminal is removed, the
grey section remains connected.
Caution:
Do not remove the bus terminal from
underneath! There is a risk of shorting the
device!
Disconnecting the bus terminal (Diagram 3 “A”)
Remove the bus terminal (C3) and the conductor (C3.4)
of the bus cable by rotating them simultaneously back-
wards and forwards.
Care instructions
The design frame and the plastic surface of the display
unit can be cleaning using conventional, solvent-free
cleaning materials. The surface of the display itself may
only be cleaned with a damp, soft cloth (e.g. cloth used
for cleaning a pair of glasses) and if necessary a mild
cleaning agent that is suitable for use on glass.
Dimension Diagram
Dimensions in mm
58
52
77
15
6
190
General Notes
•
Any faulty devices should be returned to the local
Siemens office.
•
If you have further questions about the product,
please contact our Technical Support:
℡
+49 (0) 180 50 50-222
"
+49 (0) 180 50 50-223
h
www.siemens.de/automation/support-request
