instabus EIB
Technical Product Information
April 2006
Touch panel UP 588
5WG1 588-2AB01
Touch panel UP 588/11
5WG1 588-2AB11
Touch panel UP 588/21
5WG1 588-2AB21
Accessories: Design frame, anodised aluminium
5WG1 588-8AB01
Siemens AG
UP 588, 6 pages
Technical Manual
Automation and Drives Group
Electrical Installation Technology
©
Siemens AG 2006
Update: http://www.siemens.de/gamma
P.O.Box 10 09 53, D-93009 Regensburg
Subject to change without prior notice
2.3.1.4/3
Location and function of the conjunction-
and operating elements
The device connections as well as the learning button
and programming LED which are required for the com-
missioning stage are accessible at the back of the de-
vice. Diagram 1 shows the back of the device.
Diagram 2: Location of the display and
operating elements
A1
Terminal compartment for the connection of the
power supply terminal
A2
Programming LED
A3
Learning button
A4
Bus terminal
A5
Latching
The connection of the bus cable is carried out via a
standard bus terminal which is inserted in the corre-
sponding terminal locator on the right-hand side of the
housing. The learning button and the programming LED
are located on the left next to the module slot for the
bus terminal. The terminal for the power supply is on
the left-hand side of the device. The terminal must be
withdrawn in order to connect the power supply cables.
A6
A6
for adjusting the contrast
The contrast of the display can be changed via potenti-
ometer. The contrast is optimally pre-set for operation
in most environments at the factory. Changes should be
made only for extreme conditions.
Mounting and wiring
General description
The device may only be installed in the flush-type box
that is supplied. For the cable entry into the flush-type
box, the bus cable must be inserted into the bottom left
opening (B3) and the power supply cable must be in-
serted into the opening on the right-hand side (B2). The
bus and power supply cable may not be fed through an
opening together into the flush-type box. Within the
box, the cable should be led so that a minimum distance
of 10mm is guaranteed between the bus and the power
supply cable.
B1
B2
B3
B4
B6
B7
B5
Diagram 3: Installation of the touch panel
A1
A2
A3
A4
LED Prog.
+
N L
-
A5
