Mechanical installation
3.3 Installing the Braking Module
Braking Module / braking resistor
Operating Instructions, 11/2017, A5E00331454A
21
6.
Attach the adapter bar to the DCNA using a nut, so that the busbar cannot be twisted. For
this purpose, a small bolt is attached to the adapter bar, which must be located on the
lower side of the DCNA connection.
7.
Secure the connecting cable to the DC link with 2 screws (Braking Module connection)
and 2 nuts (DC-link connection).
Carry out the subsequent steps in reverse order from steps 1 – 3.
An opening above the connections for the braking resistor (R1, R2) is provided in the cover
for connecting the cable to the braking resistor.
Note
Pay attention to the tightening torques
You must observe the tightening torques. Information on this can be found in the table in the
"Mechanical installation" section
