Mechanical installation
3.3 Installing the Braking Module
Braking Module / braking resistor
20
Operating Instructions, 11/2017, A5E00331454A
Figure 3-5
Installing the Braking Module in a Power Module, frame size FX – steps 4 - 7
Installing the Braking Module
The steps for the installation procedure are numbered in accordance with the figures in the
diagrams.
1.
Unscrew the 2 M6 screws from the front cover and lift off the cover.
2.
Unscrew the 2 screws from the upper cover plate.
Unscrew the M6 nut on the left-hand side and remove the front cover.
3.
Unscrew the 4 screws from the upper cover plate.
Unscrew the 3 screws from the rear cut-out sections and remove the rear cover.
4.
Unscrew the 3 screws for the blanking plate and remove the plate.
5.
Insert the Braking Module where the cover used to be and secure it using the 3 screws
(from step 4).
