Siemens SIMOTICS DC 1GH5, Operating And Installation Instructions

Page: 73 / 130

8.9.3 Roller bearing faults
Note
Damage to roller bearings can be difficult to detect in some cases. If in doubt, replace the
bearing. Use other bearing designs only after consulting the manufacturer.
Table 8-3 Roller bearing faults
↓ Bearing overheats
↓ Bearing "whistles"
↓ Bearing "knocks"
Possible causes of faults Remedial measures
X High coupling pressure Align the machine more accurately.
X Belt tension too high Reduce the drive belt tension.
X Bearing contaminated Clean the bearing or replace it. Check the seals.
X High ambient temperature Use a suitable high-temperature grease.
X X Insufficient lubrication Grease the bearings as instructed.
X X Bearing canted Properly install the bearing.
X X Insufficient bearing play Only after consultation with the manufacturer: Fit a bearing with
greater play.
X Excessive bearing play Only after consultation with the manufacturer: Fit a bearing with
lower play.
X X Bearing corroded Replace the bearing. Check the seals.
X Too much grease in bearing Remove surplus grease.
X Wrong grease in the bearing Use the correct grease.
X Friction marks on raceway Replace the bearing.
X Scoring (brinelling) Replace the bearing. Avoid any vibration at standstill
Operation
8.9 Faults
SIMOTICS DC 1GH5
Operating Instructions 02/2016
73